Dell XPS/Dimension XPS Gen 2 - Manual (Page 21)

Removing the Processor Airflow Shroud
1. Follow the instructions in " Before You Begin ."
2. Open the computer cover.
3. Press down and back on the indentations at the top corners of the shroud.
The top anchor tabs disengage from the anchor slots.
4. Lift the airflow shroud out of the chassis.
Installing the Processor Airflow Shroud
1. Follow the instructions in " Before You Begin ."
2. Open the computer cover.
3. Insert the bottom anchor tabs into the anchor slots.
4. Align and insert the side anchor tabs into the anchor slots.
5. Press the indentations until the top anchor tabs on the shroud snap securely into place.
6. Close the computer cover .
7. Connect your computer and devices to electrical outlets, and turn them on.
Processor
Installing the Processor
1. Follow the instructions in " Before You Begin ."
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION: Before you perform this procedure, follow the safety instructions in your Owner's Manual.
NOTE: It is recommended that only a technically knowledgeable person perform this procedure.
CAUTION: The processor can get very hot during normal operation. Ensure that the processor has had sufficient time to cool before you touch it.