Dell XPS 13 (L321X, Early 2012) - Manual (Page 28)

28 Solid-State Drive
3 Slide and remove the solid-state drive out of the system-board connector.
Replacing the Solid-State Drive
1 Align the notch on the solid-state drive with the tab in the
system-board connector.
CAUTION: Use firm and even pressure to slide the solid-state drive into place.
If you use excessive force, you may damage the connector.
2 Insert the solid-state drive connector at a 45-degree angle into the
system-board connector.
3 Replace the screw that secures the solid-state drive to the system board.
4 Adhere the tape over the solid-state drive.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 18.
2 Replace the power-light board. See "Replacing the Power-Light Board" on
page 16.
3 Replace the base cover. See "Replacing the Base Cover" on page 14.
4 Follow the instructions in "After Working Inside Your Computer" on page 11.
1 screw 2 system-board connector
3 solid-state drive
2
3
1
OM_Book.book Page 28 Tuesday, September 25, 2012 2:30 PM