Dell PowerEdge M610x User Manual
Page 272
272
Installing Blade Components
Video Controller (PowerEdge M905, M805, M605,
and M600 Only)
Follow these steps to remove and replace the video controller:
1 Remove the blade. See "Removing a Blade" on page 155.
2 Open the blade. See "Opening the Blade" on page 159.
3 Remove the video controller:
• If you are removing the video controller from a PowerEdge M905, M805,
or M605, remove the two torx screws securing the daughter card, then
lift the card from the blade. See Figure 3-59.
• If you are removing the video controller from a PowerEdge M600, press
the latch on the upper edge of the video riser card, then lift the card
from the blade. See Figure 3-58.
Figure 3-58. Removing and Installing a Video Riser Card (PowerEdge M600 Shown)
1
video riser card
2
latch
3
connector on system board
1
2
3