The blade chassis. see figure 3-60 – Dell PowerEdge M610x User Manual
Page 275
Advertising
Installing Blade Components
275
Figure 3-60. Removing and Installing the Hard-Drive Backplane (M915 Shown)
5 To install the hard-drive backplane:
a
Hold the backplane with the drive connectors facing towards the hard
drive bays.
b
Position the backplane so that the retention hooks on the end of the
drive bay are aligned with the corresponding slots in the backplane.
c
Press the backplane into place until the connector is fully seated and
the latches at each end snap over the upper edge of the board.
1
hard-drive backplane (2)
2
hard-drive connectors (2)
3
retention hooks (4)
4
latches (4)
5
backplane connector (2)
3
2
5
1
4
Advertising