Dell 4310WX Projector - Manual (Page 26)

26 Using Your Projector
1 LAMP warning light If the LAMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Lamp is reaching its end of usable life
• Lamp module is not properly installed
• Lamp driver failure
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 63 and "Guiding Signals" on
page 67.
2 TEMP warning light If the TEMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Internal temperature of the projector is too
high
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 63 and "Guiding Signals" on
page 67.
3 Power Turns the projector on or off. For more
information, see "Turning Your Projector On" on
page 21 and "Turning Your Projector Off" on
page 21.
4 Up / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+40/-35 degrees).
5 Right / Auto Adjust Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to synchronize the projector to the input
source.
NOTE: Auto Adjust does not operate if the
on-screen display (OSD) is displayed.
6 IR Receiver Point the remote control towards the IR receiver
and press a button.