Dell P2014H Monitor - Manual (Page 12)

22  Setting Up the Monitor Setting Up the Monitor  23
Connecting the White DVI Cable Setting Up the Monitor
Attaching the Stand
NOTE: The stand is detached from monitor when it is shipped from the
factory.
NOTE: This is applicable for a monitor with a stand. When any other
stand is bought, please refer to the respective stand setup guide for set
up instructions.
Connecting the Blue VGA Cable
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the
back of the monitor.
3. Press the stand till it snaps into its place.
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section,
follow the
Safety Instructions .
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
CAUTION: The graphics are used for the purpose of illustration only.
2. Connect either the white (digital DVI-D) or the blue (analog
Appearance of the computer may vary.
VGA) display connector cable or the black( DisplayPort) to the
corresponding video port on the back of your computer. Do not
connect both cables on the same computer. Use both the cables
only when they are connected to two different computers with
appropriate video systems.
Connecting the black DisplayPort Cable