Dell OptiPlex GX260 User Manual
Page 131
2. Release the card-clip lever, ensuring that the tab on the card-clip lever fits into the notch on the front end of the card.
3. Secure the card by lowering the hinged lever on the back panel.
4. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the
computer.
5. Connect the monitor cable to the card's video connector.
6. Connect your computer and devices to electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear
on the screen at the next computer start-up:
ALERT! Cover was previously removed.
7.
Reset the chassis intrusion detector
by changing Chassis Intrusion to Enabled or Enabled-Silent.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for
information on resetting the chassis intrusion detector.