Dell Wake-on-LAN - Manual (Page 15)

October 2007 Page 15 Dell Enterprise Product Group
6. Restart the server. After the server has restarted, if the NIC is not already
connected to a switch or hub, connect it and shut the server down.
7. Shut the system off. The connection LED on the NIC and switch or hub will
remain on indicating the NIC is monitoring the network for wake up packets
directed to its MAC address.
8. Send a wake up signal to the MAC address of the WOL enabled NIC, and the
system will boot.
Note: If the system boot is interrupted before the OS and the NIC driver are loaded, the
system will not be able to perform WOL again until the system is rebooted manually and
the OS and driver are allowed to load and reset the NIC’s WOL registers.
©Copyright 2003‐2008 Dell Computer Corporation. All rights reserved. Reproduction in any manner whatsoever
without the express written permission of Dell Computer Corporation is strictly forbidden. For more information, contact
Dell. Dell cannot be responsible for errors in typography or photography.
Trademarks used in this text: Dell, PowerEdge, and OpenManage are trademarks of Dell, Inc.; Microsoft, Windows, Windows
NT, and Windows Server are registered trademarks of Microsoft; Intel is a registered trademark of Intel Corporation.; Red
Hat and Red Hat Enterprise Linux are registered trademarks of Red Hat, Inc.; Novell and NetWare are registered trademarks
of Novell, Inc.; SUSE is a registered trademark of SUSE Linux Products GmbH. Other trademarks and trade names may
be used in this document to refer to either the entities claiming the marks and names or their products. Dell disclaims any
proprietary interest in trademarks and trade names other than its own.
Information in this document is subject to change without notice. The content is provided as is, without express or
implied warranties of any kind.