Dell Latitude D620 ATG - Manual (Page 32)

11. Remove the seven M2.5 x 8-mm screws from the bottom of the computer.
12. Turn the computer top-side up and remove the palm rest.
a. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base by lifting the inside edge of the palm rest.
b. After the back of the palm rest is unsnapped, push the palm rest slightly forward to unhook the remainder of the palm rest from the front of the
base.
13. Disconnect the touch-pad cable connector from the system board.
Back to Contents Page
NOTICE: Carefully separate the palm rest from the base to avoid damage to the palm rest.
1 touch pad connector
NOTICE: When reinstalling the palm rest, ensure that you reconnect the touch pad cable connector to the system board before replacing the palm rest
screws.