Dell Latitude CSx H - Manual (Page 99)

4. Double-click the Display icon.
The Display Properties window appears.
5. Click the Settings tab and then click Advanced....
6. Click the Adapter tab and then click Change....
7. When the Update Driver Wizard appears, click Next>.
8. Select Display a list of all the drivers in a specific location, and click Next>.
9. When prompted for the location of the drivers, click Have Disk....
10. In the Install from Disk window, verify that a:\ is displayed in the Install from Disk field, and click OK.
The Select Device window appears.
11. Make sure that NeoMagic MagicGraph 256ZX is highlighted, and click OK.
12. In the Update Device Driver Wizard window, click Next> to begin copying the files, and then click Finish.
13. Close the Display Properties window.
14. When prompted to restart the computer, remove the diskette and then click Yes.
After installing the video drivers and restarting your computer, set the display parameters by performing the following steps:
1. Click the Start button, point to Settings, and then click Control Panel.
The Control Panel window appears.
2. Double-click the Display icon.
The Display Properties window appears.
3. Click the Settings tab.
4. Change the Color palette option from 256 colors to True Color (24 bit).
5. Set the Desktop area for your display to 1024 x 768.
6. Click Apply.
Installing Audio Drivers
Dell provides audio drivers so that you can customize the audio features of yoru computer. To install the audio drivers, perform the following steps:
1. Save your work in all open application programs, because you will need to restart your computer at the end of this procedure to complete the
installation.
2. Insert the audio driver diskette into the diskette drive.
3. Click the Start button, then click Run....
The Run dialog box appears.
4. Type a:\setup, and then click OK or press <Enter>.
5. Follow the instructions on your display.
6. After the files are copied to your hard-disk drive, click Finish.
Installing Software Wavetable
The software wavetable allows you to customize certain audio features. To install the software wavetable, perform the following steps:
1. Save your work in all open application programs, because you will need to restart your computer at the end of this procedure to complete the
installation.
2. Insert the first software wavetable diskette into the diskette drive.