Dell XPS M170 (MXG051, Late 2005) User Manual
Page 15
4.
Turn the computer top-side up.
5.
Remove the
center control cover
.
6.
Open the display all the way (180 degrees) so that it lies flat against the work surface.
7.
Use the pull-tab to disconnect the display cable, and then disengage the display cable from the cable channel.
8.
Use the pull-tab to disconnect the LED cable, and then disengage the LED cable from the cable channel.
9.
Remove the four M2.5 x 5-mm screws (two on each side) that connect the display to the computer base.
1
antenna cables
1 display cable pull-tab
2 M2.5 x 5-mm screws (4)
3 Mini PCI card antenna cables (2)
4 display cable connector on system board
1 LED cable
2 Mini PCI card antenna cables
NOTE:
When removing the display assembly, carefully thread the Mini PCI card antenna cables through the computer base.