Drive hardware removal (midsize chassis): dell, Optiplex, G1 systems – Dell OptiPlex G1 User Manual
Page 67
Drive Hardware Removal (Midsize Chassis): Dell
™
OptiPlex
™
G1 Systems
3.5-Inch Diskette Drive Removal
5.25-Inch Drive Assembly Removal
Hard-Disk Drive Bracket Removal
|
Hard-Disk Drive Assembly Removal
Drive Hardware
3.5-Inch Diskette Drive Removal
To remove the 3.5-inch diskette drive, follow these steps:
1. Disconnect the DC power cable and the interface cable from the back of the 3.5-inch diskette drive.
2. Remove the bracket-mounting screw.
3. Rotate the left side of the 3.5-inch diskette drive up, and lift the drive out of the chassis.
4. Remove the two drive-mounting screws from the left side of the drive, and remove the drive from the bracket.
When you replace the 3.5-inch diskette drive, be sure that the two hooks on the right side of the bracket engage the mounting holes in the side of the 3.5-inch diskette
drive.
5.25-Inch Drive Assembly Removal