Dell Inspiron Small Desktop (3647, Late 2013) - Manual (Page 35)

Replacing the Front I/O Panel | 35
Replacing the Front I/O Panel
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Insert the front I/O panel clamps into the slots on the front panel.
2 Slide the front I/O panel toward the side. Ensure that the screw hole on the
front I/O panel aligns with the screw hole on the front panel.
3 Replace the screw that secures the front I/O panel to the front panel.
4 Route the front I/O panel cables through the routing guides on the chassis.
5 Connect the front I/O panel cables to the system-board connectors (USBF1, USBF2,
and AUDF1 ). See "System-Board Components" on page 11.
Postrequisites
1 Replace the graphic card, if applicable. See "Removing the Graphics Card" on
page 19.
2 Replace the drive cage. See "Replacing the Drive Cage" on page 28.
3 Replace the front bezel. See "Replacing the Front Bezel" on page 25.
4 Replace the fan shroud. See "Replacing the Fan Shroud" on page 15.
5 Replace the computer cover. See "Replacing the Computer Cover" on page 13.
book.book Page 35 Monday, November 25, 2013 3:53 PM