Dell PowerEdge C6220 - Manual (Page 148)

148 | Installing System Components
Hard Drives
Removing a 3.5-inch Hard-Drive Blank
CAUTION: To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
NOTE: This section is applicable to systems with hot-swappable hard drives only.
1 Pull the hard-drive blank out of the hard-drive bay. See Figure 3-3.
Figure 3-3. Removing or Installing a 3.5-inch Hard-Drive Blank
1 3.5-inch hard-drive blank
Installing a 3.5-inch Hard-Drive Blank
1 Slide the hard-drive blank into the drive bay until the hard-drive blank
is seated in place. See Figure 3-3.