Dell C7765DN MFP Color Laser Printer - Manual (Page 82)

Dell C7765dn Security Target
- 78 -
7.1.4. System Administrator’s Security Management (TSF_FMT)
To grant a privilege to a specific user, this function allows only the authorized system administrator to
access the system administrator mode which enables him/her to refer to and configure the settings of
the following TOE security functions from the control panel or system administrator client.
(1) FMT_MOF.1 Management of security functions behavior
FMT_MTD.1 Management of TSF data
FMT_SMF.1 Specification of management functions
The TOE provides a user interface which allows only the authenticated system administrator to
refer to / change the TOE setting data related to the following TOE security functions and to make
setting whether to enable/disable each function.
With these functions, the required security management functions are provided.
The settings of the following TOE security functions can be referred to and changed from the
control panel.
・ Refer to the setting of Hard Disk Data Overwrite, enable/disable it, and set the number of pass
(overwrite procedure);
・ Refer to the setting of Hard Disk Data Encryption and enable/disable it;
・ Set the cryptographic seed key for Hard Disk Data Encryption;
・ Refer to the setting on the use of password entered from MFD control panel in user
authentication, and enable/disable it;
・ Refer to the setting of access denial due to authentication failure of system administrator
identification, enable/disable it, and set the allowable number of the failures before access
denial;
・ Change the key operator ID and password (only a key operator is privileged);
・ Refer to the setting of access denial due to authentication failure of system administrator,
enable/disable it, and set the allowable number of failures;
・ Refer to and set the minimum password length (for general user and SA, with local
authentication only);
・ Refer to the setting of SSL/TLS communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of IPSec communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of S/MIME communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of User Authentication and select disable/Local Authentication/Remote
Authentication, and configure the details;
・ Refer to the setting of Smart Card authentication, enable/disable it, and configure the details;
・ Refer to the setting of Store Print and set store/print;
・ Refer to and set date and time;
・ Refer to the setting of Self Test and enable/disable it;