Dell PowerVault 745N - Manual (Page 58)

l Connect the remote access controller cable to the bottom of the remote access controller. See Figure 6 -9 .
6. Insert the expansion card firmly into the expansion-card connector on the riser board until the card is fully seated, being careful not to remove the riser
board from the system board.
7. Replace the expansion-card retainer. See Figure 6 -7 .
8. Connect any remaining internal or external cable(s) to the expansion card.
9. If installing a remote access controller, connect the cable to the remote access controller connector on the system board. See Figure 6 -9 .
10. Replace the daughter card if it was removed. See " Installing a Daughter Card ."
11. Close the system. See " Closing the System " in "Troubleshooting Your System."
Figure 6-7. Installing and Removing Expansion Cards
Figure 6-8. Installing and Removing a CERC SATA RAID Controller
Figure 6-9. Installing and Removing a Remote Access Controller
NOTE: Ensure that the expansion-card bracket is also inserted into the securing slot on the chassis's back panel.