Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 31)

Installing the Feature Pack
Feature Pack Deployment Guide 31
To install the Feature Pack components using the Setup wizard
1. Launch the Feature Pack Installation Web Interface. The Installation Web Interface is
launched when the 'WSS 2003 Feature Pack' installation package is first run on the NAS
system. To subsequently launch the Installation Web Interface, double click on install.htm,
located in the c:\Dell\Install\Feature Pack folder.
2. From the Feature Pack Installation Web Interface, click the Installation Tab. Next, click the
Feature Pack Installation link. Read the End User License Agreement. You must accept the
EULA to continue installation. If prompted by the browser, select Open.
3. Follow the instructions to complete the installation.
Note
The Windows Storage Server computer does not require a reboot after Feature Pack
installation.
4. Once Feature Pack installation is complete, return to the Installation Web Interface. To install
updates to the Feature Pack, click any included Hotfix Installation links. If prompted by the
browser, select Open.
5. Follow the instructions to complete the installation.
6. Visit the Downloads section of your PowerVault NAS System at http://support.dell.com for
the latest updates to the Feature Pack.
To install Feature Pack components from a command prompt
1. At the command prompt, navigate to the folder c:\Dell\Install\Feature Pack\Setup.
Note
If the folder does not exist, the ‘WSS 2003 Feature Pack’ installation package must
be run from the NAS system. This will place all necessary installation files in the
c:\Dell\Install\Feature Pack folder.
2. At a command prompt, type the following:
Setup.exe /i /qn where:
/i is the parameter that denotes the operation as an installation.
/qn allows the installation to run without user intervention.
3. Once Feature Pack installation is complete, install all included hotfixes.
4. Visit the Downloads section of your PowerVault NAS System at http://support.dell.com for
the latest updates to the Feature Pack.
Note
The Setup.exe program uses the same parameters as Windows Installer
(Msiexec.exe). All Windows Installer arguments can be used when running Setup.exe
from the command line. For more information about Windows Installer arguments,
see "Command Line Options" in the Windows Installer documentation in the
Platform
Software Development Kit (PSDK) at the Microsoft Web site
(
http://msdn.microsoft.com ).