Dell PowerVault NX1950 - Manual (Page 11)

Configuring 3.1 Target
11
5 Repeat step 1 to step 4 on the other node(s) and reboot.
NOTE:
The Dell Software Initialization Wizard and Microsoft Management
Console are displayed when you restart the PowerVault NX1950 storage
solution. You must close the Microsoft Management Console before installing
the new Target.
6 Download the iSCSI 3.1 Software Target from the Dell Support website at
support.dell.com and install on all cluster nodes one at a time.
To uninstall the current 3.0 Target that is configured in a non-clustered
environment:
1 Close all applications.
2 From the Initiator, disconnect all Initiators from the Target(s).
3 Navigate to Add or Remove Programs and uninstall the Microsoft iSCSI
Target from the passive node(s) and allow for complete reboot.
4 Reboot the PowerVault NX1950 storage solution.
NOTE:
The Dell Software Initialization Wizard and Microsoft Management
Console appear when you restart the PowerVault NX1950 storage solution.
You must close the Microsoft Management Console before installing the
new Target.
NOTE:
Ensure that your system is running Microsoft Windows Unified Data
Storage Server 2003 SP2 which is a pre-requisite for the Active/Active Target
configuration.
5 Download and save the 3.1 Target from the Dell Support website at
support.dell.com on the PowerVault NX1950 storage system.
6 Install the 3.1 Target on the PowerVault NX1950 storage system.
NOTE:
After the 3.1 Target is successfully installed, you may be prompted to
create highly available iSCSI instance. Close the window and perform the
steps in "Creating a Target in a Non-Clustered Environment" on page 14 to
create a new Target.