Graphics card, Removing the graphics card, Replacing the graphics card – Dell Inspiron Zino HD (410, Mid 2010) User Manual
Page 10
Back to Contents Page
Graphics Card
Dell™ Inspiron™ 410 Service Manual
Removing the Graphics Card
1.
Follow the procedures in
Before You Begin
.
2.
Remove the bottom cover (see
Removing the Bottom Cover
).
3.
Remove the two screws that secure the graphics card to the system board.
4.
Remove the graphics card from the system board connector.
Replacing the Graphics Card
1.
Follow the procedures in
Before You Begin
.
2.
Align the notch on the graphics card with the tab in the system-board connector.
3.
Insert the graphics card at a 45-degree angle into the system board connector.
4.
Press the other end of the graphics card down and replace the two screws that secure the graphics card to the system-board connector.
5.
Replace the bottom cover (see
Replacing the Bottom Cover
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
graphics card
2
screws (2)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.