Optical drive, Removing the optical drive, Replacing the optical drive – Dell Inspiron Zino HD (410, Mid 2010) User Manual
Page 25
Back to Contents Page
Optical Drive
Dell™ Inspiron™ 410 Service Manual
Removing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Remove the top cover (see
Removing the Top Cover
).
3.
Remove the top bracket (see
Removing the Top Bracket
).
4.
Disconnect the optical-drive cable from the connector on the optical drive.
5.
Push and slide the optical drive out through the front of the computer.
Replacing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Slide the optical drive into the drive bay.
3.
Connect the optical-drive cable to the connector on the optical drive.
4.
Replace the top bracket (see
Replacing the Top Bracket
).
5.
Replace the top cover (see
Replacing the Top Cover
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
optical-drive cable connector
2
drive bay
3
optical drive
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.