Setting up the monitor, Attaching the stand, Connecting your monitor – Dell G2210 Monitor User Manual
Page 28
Back to Contents Page
Setting Up the Monitor
Dell™ G2210/G2410 Flat Panel Monitor User's Guide
Attaching the Soundbar (Optional)
Attaching the Stand
Remove the monitor cover and place the monitor on it.
1.
Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
2.
Lower the stand so that the monitor mounting area snaps onto the stand.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not connect both cables on the same computer.
Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the White DVI Cable
NOTE:
The stand is detached from monitor when it is shipped from the factory.
CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.