Dell PowerVault DP500 - Manual (Page 10)

10
Introduction
2 In the Microsoft iSCSI Software Target console, right-click iSCSI Target,
and then click Create iSCSI Target. The Welcome to the Create iSCSI
Target wizard screen appears. Click Next.
The wizard guides you through the process of Target creation.
3 The Create iSCSI Target wizard displays the iSCSI Target Identification
option. Enter a Name and Description (optional) for the iSCSI Target.
Click Next.
4 The iSCSI Initiators Identifiers screen appears. Click Browse and select the
IQN of the host that you are configuring the Initiator to connect to. The
host IQN is listed only if Initiator configuration was completed
successfully.
NOTE:
You must fill the IQN identifier field. You can type the Initiator IQN
identifier or use the Browse and Advanced options in the screen to add the
IQN identifier. For more information about the Browse option, see step 5.
For more information about the Advanced option, see step 6.
5 If you choose the Browse option, select the IQN identifier by performing
the following steps:
a The Add iSCSI Initiator screen appears and the details for iSCSI
Initiator list are displayed. You can type or select iSCSI Initiator from
the list, enter the iSCSI Initiator Name, and click OK.
b The IQN identifier field in the iSCSI Initiators Identifiers screen is
populated with the value you had entered or selected. Click Next.
6 If you choose the Advanced option, select the IQN identifier by
performing the following steps:
a The Advanced Identifiers screen appears. Click Add.
b The Add/Edit Identifier appears and you are provided with four
options, namely—IQN, DNS Domain Name, IP address, and MAC
Address to add the IQN identifier. Choose any one of the four
options.
NOTE:
If you choose MAC address as the IQN identifier, ensure that you
enter the MAC address in the same format that it is displayed. Each octet
should be separated by a hyphen. For example, 00-08-74-4C-7F-1D.