Target settings, Initiator settings continued – Dell PowerVault DP500 User Manual
Page 34
34
iSCSI Connections Using Challenge-Handshake Authentication Protocol
Target Settings
1 Configure the Target settings of CHAP as described in "iSCSI Target
Settings" on page 32 and perform the following steps:
a
In the <Target Name> Properties window, select the Authentication
tab.
b
Select the check box for Enable reverse CHAP authentication. In the
User name field, enter the IQN of the Initiator.
c
In the Reverse secret field enter the Secret value that you set in the
Initiator.
NOTE:
Ensure that the Reverse secret is not the same as the CHAP secret.
The Reverse secret must contain 12 to 16 characters.
Initiator Settings Continued
1 Configure the Initiator settings for CHAP as described in "iSCSI Initiator
2 In the Advanced Settings window→ select CHAP logon information→
enter the User name and Target secret. Select the check box for Perform
mutual authentication and click OK.
You can log in only if you have credentials that you entered for the Target
and Initiator.