Dell Latitude C600 - Manual (Page 36)

36 Removing and Replacing Parts
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
Removing the Display-Feed Flex Cable (12.1-Inch Display Panel)
D i s p l a y - Fe e d F l e x C a b l e
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
1 Remove the hard drive.
2 Remove the display assembly.
3 Remove the display assembly bezel.
4 Remove the four M3 x 3-mm screws that secure the display panel to
the support bracket (see “12.1-Inch Display Assembly Bezel and
Panel”).
5 Lift the bottom of the display panel out of the display-assembly top
cover.
display panel
connector
inverter
connector
bottom flex
cable connector
top flex
cable connector
pull tab