Replacing the computer cover – Dell OptiPlex SX270 User Manual
Page 44
Back to Contents Page
Replacing the Computer Cover
Dell™ OptiPlex™ SX270 Systems User's Guide
1.
Ensure that no tools or extra parts are left inside the computer.
2.
Replace the cover:
a.
Lower and align the cover with the two lines on the metal computer frame.
a.
Slide the cover until you hear or feel it click into place.
3.
Connect your computer to its power adapter and connect devices to electrical outlets, and turn them on.
After you replace the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer
start-up:
ALERT! Cover was previously removed.
4.
Reset the chassis intrusion detector
by changing Chassis Intrusion to Enabled or Enabled-Silent.
Back to Contents Page
1 alignment lines
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.