Dell PowerEdge T710 - Manual (Page 92)

92
Installing System Components
Figure 3-7. Installing a Hot-Swap Hard Drive
3 Install the hot-swap hard drive.
a Press the button on the front of the drive carrier and open the handle.
b Insert the hard-drive carrier into the drive bay until the carrier
contacts the backplane.
c Close the handle to lock the drive in place.
4 Replace the front bezel. See "Installing the Front Bezel" on page 85.
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-8.
1 release button 2 hard drive carrier handle
2
1
book.book Page 92 Monday, June 15, 2009 11:33 AM