Dell Dimension 2350 - Manual (Page 46)

IDE Primary Master Submenu
Diskette Configuration Submenu
IDE Primary Slave Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the same
as the one described in "
IDE Primary Master Submenu ."
IDE Secondary
Master Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
described in "
IDE Primary Master Submenu ."
IDE Secondary Slave Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
described in " IDE Primary Master Submenu ."
Option Function
IDE HDD Auto-Detection Press <Enter> to start auto-detection for the primary IDE hard drive.
IDE Primary Master Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual.
Capacity Displays the maximum capacity of the primary IDE device.
Cylinder, Head, Precoup, Landing Zone,
Sector Displays each setting of the primary IDE device.
Access Mode Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large.
PIO Mode Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3,
and Mode 4.
UDMA Mode Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled.
Option Function
Diskette Controller Configures the floppy drive interface. Options are Enabled (default) and Disabled.
Drive A: Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in.
Floppy 3 Mode
Support Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A.