System board, Connect the data cable to the drive and to the, Connect the power cable to the – Dell Dimension 3000 User Manual
Page 26: Replacing the fan assembly, Removing the system board
5.
Disconnect the fan power cable from its connector on the system board.
6.
Pull the fan release lever away from the back of the computer and slide the fan toward the release lever.
7.
Remove the fan assembly from the computer.
Replacing the Fan Assembly
1.
Align the fan assembly tabs with the holes in the back of the computer.
2.
Slide the fan assembly away from the fan release lever until it clicks in place.
3.
Reconnect the DC power cables to the drives and system board.
4.
Replace the computer cover.
5.
Connect the AC power cable to the AC power connector on the back of the power supply.
6.
Connect your computer and devices to electrical outlets, and turn them on.
System Board
Removing the System Board
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.