Compaq TFT5015s - Manual (Page 10)

8 Compaq TFT5015 User’s Guide
Removing the Monitor Base
Before you can mount the monitor on a swing arm or other
mounting fixture, you must remove the monitor from the base.
CAUTION: Before beginning to disassemble the monitor, be
sure the monitor is turned off and the power and signal cables
are both disconnected.
To remove the monitor from the base, complete the following
steps:
1. Disconnect and remove the signal and power cables from the
back of the monitor.
2. Remove the cover (1) from the base mounting bracket by
pulling it upward (2).
3. Lay the front bezel down on a soft area to prevent it from
getting scratched, defaced, or broken.
4. Remove the four screws (3) as shown in the illustration.