For your safety read before operating, Page 10 – Louisville Tin and Stove HEDV254A User Manual
Page 10
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1.
Set the thermostat to lowest setting.
2.
Turn off all electric power to the appliance if service is to be performed.
3.
Turn gas control knob clockwise
to “OFF”. Do not force.
A.
This appliance does not have a pilot. It is
- If you cannot reach your gas supplier, call
equipped with an ignition device which
the fire department.
automatically lights the burner. Do not try
to light the burner by hand.
C.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
B.
BEFORE OPERATING smell all around the
not push in or turn by hand, don’t try to repair
appliance area for gas. Be sure to smell next
it, call a qualified service technician. Force or
to the floor because some gas is heavier than
attempted repair may result in a fire or explosion.
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
D.
Do not use this appliance if any part has been
- Do not try to light any appliance.
under water. Immediately call a qualified service
- Do not touch any electric switch; do not
technician to inspect the appliance and to
use any phone in your building.
replace any part of the control system and any
- Immediately call your gas supplier from a
gas control which has been under water.
neighbor’s phone. Follow the gas supplier’s
instructions.
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
Gas control knob shown
in “OFF” position
1.
STOP! Read safety information on this label.
7.
Wait five (5) minutes to clear out any gas. If
2.
Set the thermostat to the lowest setting.
you smell gas, STOP! Follow “B” in safety
3.
Turn off all electric power to the appliance.
information on this label. If you don’t smell
4..
This appliance is equipped with an ignition device
gas, go to next step.
which automatically lights the burner. Do not try 8.
Turn gas control knob counterclockwise
to light the burner by hand.
to “ON”.
5.
Remove cabinet to access gas control knob.
9.
Turn on all electric power to the appliance.
6.
Turn gas control knob clockwise
to
10.
Set thermostat to desired setting.
“off”. Do not force.
11.
If the appliance does not operate, follow
instructions “To Turn Off Gas To Appliance”
and call your service technician or gas
supplier.
12.
Replace cabinet.
Page 10