Vermont Casting VC3624GS - Manual (Page 11)

9
1. Assemble the door handle components as
shown. With the handle washer and spring
mounted to the door handle, insert the door
handle into the front of the door as shown.
2. Place the mounting plate onto the backside
of the door panel, capturing the door handle.
Thread the bolts and washers into the back
side of the door and tighten them securely.
3. Place the name plate onto the front of the
door panel as shown below. From the back
side of the door, place push nuts onto the
mounting prongs of the name plate.
Tools needed:
Assembly Step 6
Phillips Head
Screwdriver
Locate these parts:
Door Handle Kit
1/4-20 x 3/8”
Bolts and
1/4-20 Lock
Washers (2 ea)
HARDWARE BAG
D
HARDWARE BAG
E
Handle Spring,
Handle Washer,
Mounting Plate
Nameplate with
Heat Indicator
Push Nuts
2 required
Door
Inside of Door