Dell POWEREDGE M905 User Manual
Page 11
Advertising
Getting Started Guide
9
3
Connect the USB type A connector on the USB cable directly to the switch USB console port.
The PowerConnect M6220 series USB console port is located on the left side of the rear
panel, as shown in Figure 2.
NOTE:
If you are installing a stack of switches, connect the terminal to the Master Switch. When a stack
is powered up for the first time, the switches elect the Master Switch, which may occupy any location in
the stack. If you connect the terminal to a member switch, you will not be able to use the CLI.
Figure 2.
Connecting to the Console Port
latch closed
latch open
JR183.book Page 9 Thursday, June 7, 2007 2:40 PM
Advertising