Pro-Ject Audio Systems Set Mediaplayer - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject Set Mediaplayer · Revision 2013.1.15
3
Connecting amplifier and speakers
The output terminals accept loudspeaker cables terminated with 4mm  Banana plugs, spades connectors
or naked wire.
Connect the cable terminals on the amplifier to the terminals on the speakers.
!
The red speaker terminals carry the positive signal (+), the black speaker terminals the negative
signal (–). Make sure the polarity of the connection is correct at each end of the cables.
Only connect one loudspeaker with an impedance not less than 4 ohms per channel.
Record output, connecting a headphone amplifier - Stereo Box S
Record Out connects an analogue record device ore a Pro-Ject Head Box headphone amplifier.
Record Out provides a fixed output level.
Connectors - Media Box S
Pro-Ject Audio Systems, Vienna, Austria
!
The Analog and the digital output cannot be used at the same time. To be able to use the analog
output, the digital output has to be disengaged in the menue and vice versa.
Make all connections whilst the Media Box S is disconnected from the power supply.
Connection to a external A/D-converter
Connect the Out S/P DIF socket to a coaxial digital input on the D/A converter or AV processor. Doing so
allows you to use the signal in its digital for further digital processing.
Mains power connection
Stereo Box S
Connect the low voltage plug from the power supply to the Power 20V
" socket before connecting the power
supply to the mains.
Media Box S
Connect the low voltage plug from the power supply to the Power 9V " socket before connecting the power
supply to the mains.
!
Never use any other power supply than the one supplied with the particular unit.