Sony BKM-FW50 - Manual (Page 11)

Computer Operation Setting items on respective
screens
Controlling the display
You can make various display settings on
the screen of the computer.
Make sure that the BKM-FW50 is properly
installed in the display, and that the BKM-
FW50, computer, and router or hub are
properly connected tvith network cable.
Then turn on power to the display, the
computer, and the router or hub.
There are five display screens, divided by
function; “Information” screen,
“Configure” screen, “Control” screen,
“Player” screen, and “Setup” screen.
For details on builonfiinctions, consult the
operating instinctions of the FWD series
product.
1
Start the browser of the computer
(Internet Explorer 6.0 or later).
2
Enter the IP address that was assigned
to the display control function into the
address field, in the format “http://
XXX.XXX.XXX.xxx”. Then press the
Enter key on the keyboard.
When a user name and password
have been set, the “Network
Password” screen appears. Enter the
user name and password that were
set, and then proceed to the next step.
3
Click the function tab at the top of the
screen and select the desired screeni
information screen
FWD series
..___
;
_
...
_
IP Mdrv^tCcfltrtf.irlv
beconilaiv
Sliptd
This screen shows the model name, serial
number and other display information, as
well as the power status and the input
signal selection.
The screen is for information only. There
are no items that can be set.
This screen also displays error information.
FWD series
For details on error infonnation, see “List
of Error Codes” (page 24).
Computer Operation 11