Sony RM-PP401 - Manual (Page 13)

Operating Non-Sony Components
You can program the remote to control non-Sony
components. Once the control signals have been
memorized, you can use those components as part of your
system.
Furthermore, you can also program this remote for Sony
componenfsThat the remote is unable to control. Note
that the remote can control the components that accept
infrared wireless control signals only.
1 Do the procedure of ''Changing the Factory Setting
of a Function Button* on page 12, if necessary.
2
Press lirSET.
'■
The program indicator lights up.
3 Press the function button for the component you
want to control (except the 5.1 IN buttons).
For example, if you are going to control a CD player,
press CD.
4 Press the numeric buttons to enter the numeric
code (or one of the codes if more than one code
exist) corresponding to the component and the
make of the component you want to control.
See the tables on pages 14 and 15 for information on
the numeric code(s) corresponding to the component
and the make of the component.
5
Press ENTER D.TUNING.
When the program indicator goes off, the
component(s) can then be controlled using this
remote.
6 Repeat Steps 2 to 5 to control other components.
'Q' If programming is unsuccessful, check the following:
• If the program indicator does not light up, the batteries are
weak. Replace both batteries.
• If you do not do Step 3 within one minute after pressing the IR
SET button in Step 2, the remote automatically exits learning
mode. Start again from Step 2.
Notes
• Programmed components will not turn on when you press a
function button. You have to turn on the component's power
switch.
• The numeric codes are based on the latest information available
for each brand. There is a chance, however, that your
component will not respond to some or all of the codes.
• All of the functions on this remote may not be available when
used with your particular component.
Clearing all programmed signals
To clear all the programmed signals, do the following
procedure. The remote is reset to its factory-setting.
1 Press IR SET to turn on the program indicator.
2 First press down MASTER VOLUME then AV 1/6,
and then SYSTEM STANDBY untii the program
indicator flashes twice, then goes off.
13