Sony ICD-V21 - Manual (Page 4)

I u-xs ivcv. ftiHi inu» thf mHM>j4K»nv
“RKC" Appears white rvci»rdini;.
You do no< гнчч1 lo к*ч‘р pri*ssin^ RHC while nrordinf;
tVi*ss KUC Agaio to stop ree<»rding.
T?H* disj>irty shows the current nwssage питЫт ami I< i I a I
numKTirf messages.
Current message number
Total number of messages
When you have rea>rdcd up lo 99 messages or the maximum
recording time, “FULL" appears in the display- If you want to record
more messages, first erase some old messages- (Refer to "Erasing
Mi'ssagcs" for details.)
To listen to the current recording
Press REC to stop recording and then press the jog lever.
To review the current recording instantly
Press the jog lever during recording.
Remaining memory Indication
As the capacity of the remaining memory decreases, the segments of
the indication will go off one by one.
When you record for about two minutes, one segment will go off.
When the remaining memory goes down to about 30 seconds, the
indication will flash, and when the memory is fulL all segments go
off.
Playing Back Messages
Jog lever
Move the jog lever to display the desired message number. (To
change the number rapidly, keep holding the lever.)
Selected message number
^ i 'ri*v. i I h * fOg cr.
TI h * •ci'k'Clcd iTH’ss.igc is playtxt hack.
3 Adjust the v«>lunu* with the VOl. control.
After playing hack «wo message, the unit stops at tlw heginniiv
the next mt's.sagc.
When llw last message has K*en playid hack, the unit stops at *
heginning (»f Hw last nn.'ssage.
other operations
To Do this
Skip lo the next message Move the jog lever upward once,
skip continuously, move the jog li
upward snd hold it there (during
mode only). "
Skip to the previou.s
message Move the jog le\*er downward on<
skip message continuously, move
jog Imer upward and hold it there
(during stop mode only).
Search forward during
playback Move the jog lever upward and h<
there, and playback release it at (Iv
message number you want to play
Search backward during
playback Move the jog lever downward and
hold it there, and release it at the
message number you want to play
To stop playbaefc partway through a message (Playback
Pause function)
Press the jog lever.
When you press the jog lever next time, the message will continu'
from tlw point where you stopped previously.
Playing back a message repeatedly (Repeat Pis
During playback, press and hold the jog lever lor more than one
second. “REP“ will be displayed and the selected message will be
played back repeatedly until you stop playback by pressing the jo
lever.
Playing all the messages continuously
(Continuous Play)
During stop mode, press and hold the jog lev'er for more than one
second. Playback starts from the message on the display and
continues playing until the end of the last message. You do not ha\
to press the jog lever for each message. (EHiring normal mode only,
not available during Shuffle mode)
When the last message has been played back, the unit stops at the
beginning of the last message.
To stop playback
Press the jog lever.
When you press the jog lever next |in\e, normal playback starts fron
the point you stopped.
Erasing Messages
You can erase the recorded messages one by one or all messages
(excluding Special Message and Shuffle Message Box) at a time.
Note that (mce a recording has been erased, you cannot retrieve it.
To erase the Special Message and the messages for the Shuffle
Measage Box, refer to the corresponding sectioos.
Total number of message