Connecting a dbs (direct broadcast, Satellite) receiver, Note – Sony KV-27V22 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting a DBS (Direct Broadcast
Satellite) receiver
1
Connect the cable from your satellite antenna
to your DBS receiver.
2
Attach the coaxial connector from your cable
or antenna to VHF/UHF on your TV.
3
Using AUDIO /VIDEO connectors, connect
AUDIO and VIDEO OUT on your DBS receiver
to AUDIO and VIDEO IN on your TV.
Connecting a DBS (Direct Broadcast
Satellite) receiver and a VCR
1
Connect the cable from your satellite
antenna to your DBS receiver.
2
Attach the coaxial connector from your cable
or antenna to VHF/UHF-IN on your VCR.
3
Using a coaxial connector, connect VHF / UHF-
OUT on your VCR to VHF/UHF on your TV.
4
Using AUDIO/VIDEO connectors, connect
AUDIO and VIDEO OUT on your DBS receiver
to AUDIO and VIDEO IN on your VCR.
5
Using AUDIO/VIDEO connectors, connect
AUDIO and VIDEO OUT on your VCR to
AUDIO and VIDEO IN on your TV.
Note:
• To view input from the DBS or VCR, select VIDEO 1
by pressing TV/VIDEO on the remote control.
For the highest picture quality, use S VIDEO instead of the
yellow AUDKWIDEO cable. (KV-27V22,29V22M only)
See your DBS manual for more information.
Disconnect all power sources before making any connections
2
DBS receiver
(Rear of TV)
VHF/UHF
»UDOR AUCHQL VOFO SVIDEO
IN
lojouT
VHFUIHF
lOEOlN
r----------- 1 AUDIO OUT
^0 vKieo -
(VAfVFlX
(MCNO)-H
-L
AUOC
R —'
1^- -R
. AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
----------------- 1-------------
VMC-810S/820S (not supplied)
VMC-810S/820S (not supplied)
-I
DBS receiver
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
VMC-810S/820S (not supplied)