Sony CCD-FX510 User Manual
Page 74
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
If an indicator blinks in the viewfinder screen and the display window or a caution lamp on the mam unit
blinks, check the following table.
slow blinking
L
fast blinking
Symptom
Cause
Corrective actions
Viewfinder
Display window
Camera or
VTR
operation
CP
CJ
The battery is weak.
Prepare a charged one.
Battery lamp
CP
CD
The battery is used up.
Use a charged battery
Battery lamp
Camera
operation
* eSB ii
*
QK3 ±
The tape is at its end.
Use a new tape.
* Battery lamp
E3!g
0!S
The tape is near its end.
Prepare a new one.
Battery lamp
No tape is inserted.
Insert a tape.
it
0!(3 ±
The tab on the tape is out
(red).
Slide the tab.
Camera or
VTR
operation
♦
GDor^
m
ISor±
Moisture condensation
has occurred.
Remove the tape and
leave the camcorder for
at least an hour.
e
—
The gap of the head is
clogged.
Clean the head using
the Sony V8-25CLH
video head cleaning
tape.
Caution lamp
♦
A
Other troubles may
occur.
Consult your rrearest
Sony dealer.
* Caution lamp
^ blinks for
five seconds
after setting the
POWER switch
to CAMERA.
—
The lithium battery is not
installed.
The lithium battery is
exhausted.
The lithium battery is
weak.
Install a lithium battery
with the battery pack or
other power source
attached. Otherwise,
you must readjust
the date, time and
birth dates.
* In these cases the displayed indicator is accompanied by a series of beeps when the BEEP
switch is turned on.
74
Additional
Information