Programming the remote control, Programming signals for non-sony components, Program a signal – Sony STR-GX900ES User Manual
Page 27: Note, Press the learn button with a ball-point pen, etc
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Remote Control
This remote can operate other components that are connected to the receiver. In
addition, the remote can literally "learn" the signals from non-Sony components and let
you control them.
Programming Signals for Non-Sony
Components
Once this remote learns the signals of the other components,
you can use other non-Sony components as part of your
system. Also if any of your other Sony components fail to
operate with this remote, use this programming function.
Your remote can "learn" only the signals from remotes that
are infrared-wireless remotes. Before you program signals,
make sure that the two remotes:
• face straight each other (as shown in step 3 below)
• are placed at a distance of approximately 2 inches (5 cm)
• are not moved during programming
LEARN indicator
2, 5
Press the FUNCTION button of the
component to be programmed.
For example, if you want to program a CD player's
remote control, press CD.
Press the LEARN button with a ball-point
pen, etc., so that the indicator lights up.
Program a signal.
On this receiver’s remote, press the button that is to
"learn" the signal from the other remote until the
LEARN indicator blinks slowly.
Other remote
Programmable area
(operative buttons)
On the other remote, hold down the button you
want the receiver's remote to "learn."
@ Remove your finger(s) from the button(s) after the
. LEARN indicator on this remote lights up.
Note
You can program only specific buttons for specific
components. See "Operative Buttons" on page 14 for a
list of the buttons that can be programmed for each
component type. If you press a button that cannot be
programmed in step ®, the LEARN indicator blinks
rapidly.
Repeat step 3 for other buttons that you
want to program.
Press the LEARN button with a ball-point
pen, etc.
The LEARN indicator lights for a few seconds.
After the indicator goes off, you can control other
components with the programmed buttons.
Note
If you do not perform the next operation in about one
minute after steps 2 and 3-®, the learning mode will be
canceled. If this happens, start again at step 1.
27