Note, An hookup, Vcr setup – Sony SLV-M10HF User Manual
Page 10: Caution, Note to catv system installer (in usa), An hookup: vcr setup, Step 3: hookups (continued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B Use this hookup if your TV has the S-Link™ function
VCR
Stereo receiver
step 3: Hookups (continued)
Note
• To play a tape in stereo, you must use the A/V connection.
AN
hookup:
VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
Set AUTO ANT SEL to OFF and
press the cursor stick (OK).
TIMER SET / CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
SET VCR Plus* CHANNELS
CABLE BOX CONTROL
ADVANCED OPTIONS
SMART FILE EDIT
AUTO STEREO
AUDIO MIX
TUNER AUDIO
SHARPNESS
DEFAULT SPEED „
Use to salect an
I lem, then push 14.
For details, see page 82.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular)
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Getting Started