COBY electronic CSMP142 - Manual (Page 11)

Page 10 Coby Electronics Corporation www.cobyusa.com Page 11
Engl
ish
Getting Started
Using the AC Power Supply
Make sure that the voltage of your electrical power supply
corresponds to the voltage indicated by the manufacturer.
If the voltage is incorrect, consult your dealer or service
center.
This unit should be used with 120V or 220V wall
outlets, only. The voltage selector on the bottom
of the unit must be set to the appropriate voltage
before connection.
Connect the electrical cord by plugging it into the wall
outlet. Keep objects clear of the cord where it connects to
the device and to the wall. Do not stretch the cord.
To completely disconnect the device from the electrical
supply, unplug the power cord from the outlet.
For your safety, unplug the device during electrical
storms.
Installing/Replacing the Remote Control Batteries
Your remote control comes with batteries pre-installed.
Remove battery insulator tape before use. Batteries should
be replaced when remote control performance diminishes
or stops.
To replace the batteries:
Open the battery door on the back of the unit. 
Remove the battery door. 