Using 75ohm coaxial cable (round), Using 300-ohm twin>lead cable (fiat), Making antenna connections – Sony KP-53V15 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Making Antenna Connections
Although you can use either an indoor or outdoor antenna with the projection TV, an outdoor antenna will
provide you with better picture quality.
You can receive cable TV by connecting a cable supplied by your local cable company.
Connecting a VHF, UHF or VHF/UHF combination antenna , or CATV cable
Check your antenna cable type. If you have 75-ohm coaxial cable (round), attach an F-type connector (not
supplied). If you have 300-ohm twin-lead cable (flat), attach a 300-75 ohm adaptor (not supplied).
Using 75ohm coaxial cable (round)
1
Prepare the end of the cable by attaching the F-type
connector as shown below.
7 mm (V4 inch) 10 mm (% inch)
F-type connector
3 mm (Vft inch)
Using 300-ohm twin>lead cable (fiat)
1
Prepare the end of the cable by attaching the 300-75
ohm adaptor as shown below.
Loosen with
a screwdriver.
Attach the
cable and
fasten with a
screwdriver.
300-75 ohm
adaptor
Í ■ V
■■ '
•l* ■ s
2
Plug the connector into the VHF/UHF terminal at the
rear of the projection TV.
Plug the adaptor into the VHF/UHF terminal at the
rear
of the projection TV.
(Rear of projection TV)
VHF/UHF
* Most combination antennas are equipped with a signal splitter.
Remove the splitter and attach the appropriate connector.
Chapter 1: Setting Up
113