Remote control direction, Notes on the remote commander, To watch the demonstration – Sony CCD-TRV12 User Manual
Page 53: To enter demo mode, To exit demo mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
Remote control direction
Aim the Remote Commander to the remote sensor within the range as shown below.
>
Q.
Notes on the Remote Commander
• Keep the remote sensor away from strong light sources such as direct sunlight or
illumination. Otherwise, the remote control may not be effective.
• Be sure that there is no obstacle between the remote sensor on the camcorder and the
Remote Commander.
• This camcorder works at commander mode VTR 2. The commander modes (1, 2, and
3) are used to distinguish this camcorder from other Sony VCRs to avoid remote
control misoperation. If you use another Sony VCR at commander mode VTR 2, we
recommend you change the commander mode or cover the remote sensor of the VCR
with black paper.
To watch the demonstration
You can watch a brief demonstration of pictures with special effects.
If the demonstration appears when you turn on the camcorder for the first time, exit the
Demo mode to use your camcorder.
To enter demo mode
(1) Eject the cassette and set the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding down ► set the POWER switch to CAMERA. Demonstration
starts. The demonstration stops when you insert the cassette.
Note that once you enter Demo mode, this mode is retained as long as the lithium
battery is in place. Therefore, demonstration starts automatically 10 minutes later every
time you set the POWER switch to CAMERA, or after you eject the cassette.
To exit demo mode
(1) Set the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding down ■ set the POWER switch to CAMERA.
53