Sony SAT-B1 - Manual (Page 63)

Using the Remote Control
After you've installed the batteries and programmed the remote
control, use these procedures to operate your system components:
1
Press the FUNCTION button of the component that you want to
operate (cable box, TV, or DSS receiver).
2
Aim the remote control at the component.
3
Press the POWER button of the component to turn it on and off.
To control other functions of the component, see the table below.
Remote Control Button
Descriptions
i: T
CABLE TV
o o O
CABLE
o
TV
o
DSS
o)
CODE SET o FAVORITE o
'“oo o
© ®
®®®
@
@
DISPLAY o
ENTER
o
o o o
Note
Buttons highlighted in the following table can also operate your TV or cable
box, if the remote has been programmed for these components. See page 70 for
instructions on programming the DSS remote.
Button Description
POWER CABLE Turns the cable box on and off.
TV Turns the TV on and off.
DSS Turns the DSS receiver on and off.
CABLE Puts the remote in cable mode. In cable mode,
the remote operates your cable box.
FUNCTION
TV Puts the remote in TV mode. In TV mode, the
remote operates your TV.
DSS Puts the remote in DSS receiver mode. In DSS
mode, the remote operates your DSS receiver.
CODE SET Used for programming the remote to operate your TV or
cable box.
FAVORITE Brings up the Favorite Station Guide, if you've created one.
When pressed repeatedly, cycles through all the Favorite
Station Guides that have been created.
TV/VIDEO Switches the input of the TV.
TV/DSS Switches the output of the DSS receiver to TV (normal TV
programs), if you've connected a TV cable or antenna, or to
DSS programs.
JUMP Tunes to the last station you were tuned to.
0-9 Specifies the station number. In menus, selects the menu
item with the corresponding number. Also, in some screens,
used to enter numerical values (such as a spending limit or
passcode).
DISPLAY Brings up (or removes) the Program Banner.
ENTER Used with 0-9 buttons to change stations without any delay
in tuning.
68 Appendix: Other Information