To monitor the sound, Votes – Sony M-527V User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To
Press or slide
Stop recording
Start recording during
playback
# during playback (the unit
becomes in the recording mode)
Review the portion just
recorded
Push up ◄ ◄ CUE/»REVffiW
toward >^REVIEW during the
recording. Release the button at the
point to start playback.
Pause recording
Slide PAUSE in the direction
of the arrow. The BAIT (M-^/
527V) or REC/BATT (M-627V/
677V/727V) lamp goes off.
Take out a cassette
■ di
/Votes
• Select the 2.4 cm tape speed for recording, if you play bade the
recorded tape with another unit Otherwise, the sound quality
may be changed.
•Be careful not to press the microphone fordbly. Otherwise, the
microphone wili be damaged and cause noise.
Notes on VOR (Voice Operated Recording) (M-527V/
627V/S77V/727V onty)
•
The VOR system depends on the environmental conditions. If
you cannot get the desired results, set VOR to OFF.
• When you use the system in a noisy place, the unit will stay in
the recording mode. If the sound is too soft, on the contrary,
the unit wili not start recording. Set VOR to H (high) or L Qow)
depending on the conditions.
To monitor the sound
Connect the earphone (not supplied) to EAR jack. The
monitor volume is fixed.
To prevent a cassette from being accidentaliy
recorded over
Break out and remove the cassette tabs. To reuse the
cassette for recording, cover the tab hole with adhesive
tape.