Sony CPD-101VS - Manual (Page 36)

Troubleshooting
This section may help you isolate a problem and as a result, eliminate the
need to contact technical support, allowing continued productivity.
No picture
If the © indicator is not lit
*> Check that the power cord is properly connected.
Check that the ® switch is in the "on" position.
If the "NO INPUT SIGNAL" message appears on the screen, or if the ©
indicator is either orange or alternating between green and orange
Try pressing any key on the computer keyboard.
Check that your computer power switch is in the "on" position.
Check that the video signal cable is properly connected and all plugs
are firmly seated in their sockets.
-> Ensure that no pins are bent or pushed in the HD15 video input
connector.
If the "OUT OF SCAN RANGE" message appears on the screen
Check that the video frequency is within that specified for the display.
Horizontal: 30 - 70 kHz
Vertical: 50 -120 Hz
Refer to your computer's instruction manual to adjust the video
frequency range.
■ > If you are using a video signal cable adapter, check that it is the correct
one.
If no message is displayed and the © indicator is green or flashing orange
See "Self-diagnosis function" (Back cover).
No sound from speaker
If the indicator is displayed
Press the button to cancel muting.
Check that the audio plug is properly connected.
Adjust the voliune with ^ +/- buttons.
-> Check that the headphones are not connected.
Check the volume control, muting, sound selector, etc. of the sound
board. (See the computer's manual.)
Microphone mixing is not possible
Check that the MIC plug is properly connected.
Check the microphone control, sound selector, etc. of the sound board.
(See the computer's manual.)
Continued to the next page
Troubleshooting 37