Sony SCT-ID10 - Manual (Page 8)

Connecting the
phone
If your telephone jack is not a nuxiular type,
please contact your telephone company for
assistance.
^Telephone Operation
Selecting the DIAL
MODE (pulse or tone)
1 Use the handset cord (supplied) to
connect the handset to the phone.
2 Plug one end of the telephone line cord
(supplied) into the LINE jack, and the
other end into a telephone outlet.
3 Connect the AC power cord into an AC
outlet.
"AREA CODE =" appears on the
display.
Note
To enter your area code, see "Entering your area
code".
IMPORTANT INSTALLATION
INSTRUaiON
1. Never itKtall telephone wiring during a
lightning storm.
2. Never install telephone jacks in wet location
unless the jack is specifically designed for wet
location.
S.Never touch uninsulated telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
4.Use caution when installing or modifying
telephone lines.
f — \
DIAL MODE
P T T: For a tone type phone line
1 P: For a pulse dial phone line
>
If you do not know which setting is correct for
your telephone line, check as follows.
1 Make a trial call with the DIAL MODE
switch set to T.
2 If the call is connected, leave the switch
at T.
Otherwise, set the switch to P.
Using Touch-Tone
Services with the Pulse
Dialing System
Some services require you to use touch-tone.
This is not a problem if your phone already uses
tone dialing. If your phone uses pulse dialing,
however, you need to follow the steps below to
use these services.
For details on making calls, see the "Making
calls" section.
1 Dial the service's number.
2 When connected to the service, press
TONE (5).
3 Press the dialing keys as required.
The line will remain in tone dialing until
disconnected.
Adjusting the
volume
Adjusting the ringer level
The RINGER LEVEL switch controls the volume of
the ringer. If you do not want to be disturbed by
telephone calls, you can turn the ringer off.
Set the
RINGER LEVEL switch to H (High), L
(Low), or OFF.
To adjust the volume level of thé
handset during conversation
Normally set HANDSET VOL to NORM. If the
sound is small set to HIGH and is too loud set to
LOW.
Entering your area
code
When you use this unit first, or vou mo\ e to an
area of the country that has a different area crxle,
you must enter your area code.
This is necessary because the phone must
distinguish local or long distance calls to
property redial calls from the Caller ID list.
1 Connect the AC power cord.
For details, see the "Telephone line
connection".
"AREA CODE =" appears on the display.
2 Enter three digits of your area code
using the dialing keys.
You hear a confirmation beep.
Checking the area code
Press DIAL.
The area code appears on the display for 20
seconds.
To change the area code
1 Press PROGRAM.
2 Press DIAL.
3 Enter a new area code using the dialing
keys.
Making Calls
You can make a call with or without picking up
the handset (the ON HOOK feature) and when
your opponent answers, pick up the handset,
1 Pick up the handset or press ON
HOOK
"==TALK==" and talk time appear on the
display.
2 Dial a phone number.
The phone number dialed appears on the
display.
Note
• If you answer a call or wish to place a call
while your clock radio is playing, the radio
automatically "mutes". The radio will resume
playing as soon as you have disconnected your
call by replacing the handset.
Receiving Calls
1 When you hear the phone ring, pick up
the handset.
The talk time appears on the display.
2 When you have finished, replace the
handset in the cradle to disconnect.