Sony SLV-SE220D - Manual (Page 14)

To Press
Switch to Teletext*' / (Teletext)
Select the sound* 2 AUDIO MONITOR
Use FASTEXT*' FASTEXT buttons
Call up the on-screen display o DISPLAY
Change the Teletext page*' c /'C
Switch to/from wide mode of a Sony wide TV (For
other manufactures’ wide TVs, see “Controlling
other TVs with the remote commander (SLV-
SE820D/E, SE727E and SX727D only)” below.)
(wide)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types ofbatteries together.
• Some buttons may not work with certain Sony TVs.
SLV-SE820D/E, SE727E and SX727D only
*^not available on SLV-SE220D
Controlling other TVs with the remote commander (SLV-
SE820D/E, SE727E and SX727D only)
The remote commander is preprogrammed to control non-Sony TVs. Ifyour
TV is listed in the following table, set the appropriate manufacturer’s code
number.
^ Set |TV| / IVIDEOI at the top of the remote commander to |TV| .
2 Hold down 1/1, and enter your TV’s code number using the programme
numberbuttons. Thenrelease 1/1.
Now you can use the following TV control buttons to control your TV:
1/1, t TV/VIDEO, programme number buttons, — (ten’s digit),
PROG +/-, 2 +/-, a (TV), / (Teletext), FASTEXT buttons,
(wide)*, MENU*, M/m/</,*, and OK*.
• These buttons may not work with all TVs.
14 Setting up the remote commander