Sony DTC-57ES - Manual (Page 31)

When the skip ID is detected during playback, the tape
skips to the next start ID position, and the normal playback
resumes. (See page 25 for details.)
Writing during Recording
Press the SKIP ID WRITE button at the beginning of
the portion you want to skip later.
The I SKIP ID I and WRITE indicators light momentarily.
The skip ID is written for about 1 second (2 seconds in
the long-play mode) from where you pressed the button.
p8TARTK)-|
PvmiTE>
j—^
Writing during Playback
During playback, skip ID can be written at the desired
position more accurately than during recording. Make sure
that the safety tab of the cassette is closed.
*1 During playback, press the SKIP ID WRITE button at
the desired position.
The REHEARSAL indicator lights and the WRITE indicator
flashes, and the portion for 3 seconds to the point where
you pressed the SKIP ID WRITE button, is played back
repeatedly (rehearsal function).
The end of the repeated portion will be the beginning of the
skip ID.
2 Press the or button to adjust the “repeat end”
point.
The “repeat end“ point shifted backward with the •«
button or forward with the button, by 0.3 of a second.
The indicator at the MARG IN shows how much the "repeat
end" point is shifted from the point where you pressed
SKIP ID WRITE.
It can be shifted up to 99 seconds backward or forward.
Note on the point where a skip ID Is written
During rehearsal function, a skip ID will be written at the
end of the repeated portion as iliustrated.
Repeated portto^
Seiection
3 seconds
Each time you 0.3
press •♦ei-
Point where you pressed
SKIP ID WRITE
Selection
Skip ID (Isecond)
Each time you press ►►
0.3
1
The repeated portion is played back 8 times, and the tape
stops.
Erasing
Make sure that the safety tab of the cassette is closed.
During playback or in the stop mode, press the SKIP
ID ERASE button immediately after the skip ID to be
erased.
The tape is rewound to the nearest skip ID position and
the skip ID is erased.
The ERASE indicator lights while the skip ID is being
searched for and goes off when the skip ID is erased.
n
I -ERASel
p Ewoe^-j
Precaution
When the skip ID and the start ID are overwritten, the skip
ID will also be erased if the start ID is erased.
When you pressed twice
ID to be erased Operation
Start ID, skip ID Press the START ID ERASE
button.
Skip ID Press the SKIP ID ERASE
button.
After setting the beginning of the skip ID at the desired
point, press the SKIP ID WRITE button again.
The I SKIP ID I indicator lights, and the skip ID is written.
31