Sony DTC-57ES - Manual (Page 35)

Various Playback Operations
Fade-in/Fade-out Play Repeat Play
t O O 1 ^ 1 ♦ 1 » 1 _ ‘a Ml rail * 1 * 1 e
Fade-in/fade-out play cannot be performed through the
digital output jack.
REPEAT
1/ALL"
QD
QlOQ|QlCa
ooa
OOP
QO
oo
m
o
ODCSoaa
(BCP(PgW
Fade-in Play
1
During playback or in the stop mode, press the
llPAUSE button.
The deck enters the pause mode.
2 Press the FADER button.
The indicator flashes, and the sound fades in.
Fade-out Play
During playback, press the FADER button at the point
where you want to start fading out.
The ifc.”Tindicator flashes, and the sound being played
back fades out.
A countdown starts, and the deck enters the pause mode
after the 0.0s indicator appears.
These functions can be performed only with the remote
commander.
To designate a desired duration of fede-in/fade-out
You can designate a desired duration of fade-in/
fade-out, from 0.2 seconds to 15 seconds.
Fade-in/fade-out is performed in 5 seconds unless you
designate a different duration.
If you turn off the unit after designating the desired
duration of fade-in/fade-out, the duration remains
memorized.
1
Choose either or by pressing
the FADER button during the stop mode.
2
Designate a desired duration by pressing the
« or button.
Each time pressing the or ►► button, a duration
in the display changes as follows:
from 0.2 sec. to 3.0 sec.: in 0.2 sec. intervals
from 3.0 sec. to 5.0 sec.: in 0.4 sec. intervals
from 5.0 sec. to 15 sec.: in 1 sec. intervals
Playing a Selection Repeatedly
Press the REPEAT 1/ALL button on the remote
commander while the desired selection is played back.
The REPEAT 1 indicator appears.
After the selection is playback, the tape is rewound to the
beginning of that selection, and the playback is repeated.
To stop playing a selection repeatedly
Press the REPEAT 1/ALL button until the REPEAT indicator
goes off.
Note on the end of the repeated portion during the REPEAT 1
play
The tape is rewound to the beginning of the selection to be
repeated when one of the following is detected,
e Start ID of the next selection
e A blank section of more than 9 seconds
e End of the tape
• Skip ID with SKIP PLAY activated
Number of times to be repeated
The selection to be repeated will be played back 16 times,
and then the tape will stop.
Playing all selections repeatedly
During playback, press the REPEAT 1/ALL button until
the REPEAT ALL indicator appears on the display.
After the tape is piayed back to the end, it is rewound to
the beginning and the playback of all selections is
repeated. In the RMS play (page 38), all the selections
programmed are played back repeatedly.
To stop playing all selections repeatedly
Press the REPEAT 1/ALL button until the REPEAT indicator
goes off.
Note on the end of the repeated portion during the REPEAT
ALL play
The tape is rewound to the beginning of the tape when one of the
following is detected,
e End ID
e A blank section of more than 9 seconds
35